Zionplayer
Junior Member
- Messages
- 28
While installing my new Schaller Minis, the head broke off the of the first screw. I figure I didn't drill deep enough into the hard maple headstock.
Pain in the ass...after waiting 6 weeks for the neck......................the other 5 went in fine...but...here is the problem...
How to exract the busted shaft.
The smallest easyout Home Depot had was a #1....and it looks a bit too big to do the job.
Other than taking it to a local luthier, (I want to build and set this project up w/o his help)...............................................
....any ideas as to where to get a small easyout capable of doing the job or other advice will be very much appreciated.
Swallowing my pride, I thank you.
Pain in the ass...after waiting 6 weeks for the neck......................the other 5 went in fine...but...here is the problem...
How to exract the busted shaft.
The smallest easyout Home Depot had was a #1....and it looks a bit too big to do the job.
Other than taking it to a local luthier, (I want to build and set this project up w/o his help)...............................................
....any ideas as to where to get a small easyout capable of doing the job or other advice will be very much appreciated.
Swallowing my pride, I thank you.