I am working on my first Bass (for a friend) and my first set of active PU's. I have searched high and low for a wiring diagram for this ESP B-4e bass. In the process of working on it, meaning pulling the wiring in and out of the cavity one wire broke off and another was hanging by a couple of strands. The pots that I had to solder are the Volume and Blend knob. (the three tone knobs are working fine) The volume is working, seemingly as it should. The blend knob is working in one direction, but turned full counter-clockwise the volume is turned all the way down.
On the volume pot I soldered the white wire to the far left lug in the pictures below. I did not see what lug the wire had broken off of, but this lug had at tiny bit of broken wire right in the middle of the solder on the lug.
On the blend knob it was the center lug that the wire broke off on. I was pretty sure that it was the lower lug, in the picture it came off of. But the top lug also has a big blob of solder with nothing connected.
I came here because the turn around time on support from ESP is a couple of days. There is no hurry to get it back to the owner but I'd really like to mark this project on the to-done list. And I know there are some really knowledgeable people on this board.
TIA
On the volume pot I soldered the white wire to the far left lug in the pictures below. I did not see what lug the wire had broken off of, but this lug had at tiny bit of broken wire right in the middle of the solder on the lug.
On the blend knob it was the center lug that the wire broke off on. I was pretty sure that it was the lower lug, in the picture it came off of. But the top lug also has a big blob of solder with nothing connected.
I came here because the turn around time on support from ESP is a couple of days. There is no hurry to get it back to the owner but I'd really like to mark this project on the to-done list. And I know there are some really knowledgeable people on this board.
TIA