Rick
Epic Member
- Messages
- 6,814
I've never installed one before and it's going to be going into my new jazzmaster build. (I'm following the instructions given to me by the good Freeway folks, using their 5B5-01 10 way selector switch) The purpose is to split the 3 mini humbuckers and the schematic calls for a 3PDT On/on switch. It has what I'd call nine lugs, in three rows of three. I also noticed in my meager internet sleuthing that there are different shaft lengths. Not sure what shaft length to get with .09 thick pickguard.
I'm going to put it into the output jack hole in the pickguard. (I'm going to put the regular mono output jack on the side.)
Any advice or sourcing info would by much appreciated.
Thanks,
Rick
PS I know nothing about electronics though I can follow directions when it comes to soldering.
I'm going to put it into the output jack hole in the pickguard. (I'm going to put the regular mono output jack on the side.)
Any advice or sourcing info would by much appreciated.
Thanks,
Rick
PS I know nothing about electronics though I can follow directions when it comes to soldering.