Acoustasonic conversion?
- Thread starter Mitch
- Start date
stratamania
Mythical Status
- Messages
- 11,983
@dc.git as @Mitch pointed out a conversion neck will need to have a tilt back
A modern construction neck which the conversion necks are unless it is a tilt back has a side adjust on the straight headstocks which is incompatible with the body.
A modern construction neck which the conversion necks are unless it is a tilt back has a side adjust on the straight headstocks which is incompatible with the body.
Will it fit my Guitar Body?
warmoth.com
JacobJames
Junior Member
- Messages
- 163
That vortex neck really compliments the guitar. 
dc.git
Newbie
- Messages
- 8
I am aware of this issue; my plan was to put a dummy screw head in the offending hole and drill a new offset hole for a fourth screw.@dc.git as @Mitch pointed out a conversion neck will need to have a tilt back
A modern construction neck which the conversion necks are unless it is a tilt back has a side adjust on the straight headstocks which is incompatible with the body.
Will it fit my Guitar Body?
warmoth.com
stratamania
Mythical Status
- Messages
- 11,983
Do you have a plan of where you will put the fourth screw?
dc.git
Newbie
- Messages
- 8
In the picture from the Warmoth website in your previous post, to the left of the "area of incompatibility". Do you foresee a problem?
stratamania
Mythical Status
- Messages
- 11,983
There is not much room to the left of that position on the neck plate for a hole to go through.
