I am wondering what tolerances Warmoth work to.
My Pbass build fit together very well.
The neck fitted very snugly in the pocket without any sanding required.
To set the action though, the bridge needed saddles as low as possible, the neck needed shimming and some turns put into the truss rod.
I suppose this might vary with the depth of the pocket and the depth of the heel as well as the size of the bridge saddles.
So as far as the depth of the pocket / the depth of the pup rout / the thickness of the neck at the heel go, what tolerances does Warmoth work to?
Is every single item QC'd to determine that it falls within those tolerances?
What happens to the bits that fall outside those tolerances?
My Pbass build fit together very well.
The neck fitted very snugly in the pocket without any sanding required.
To set the action though, the bridge needed saddles as low as possible, the neck needed shimming and some turns put into the truss rod.
I suppose this might vary with the depth of the pocket and the depth of the heel as well as the size of the bridge saddles.
So as far as the depth of the pocket / the depth of the pup rout / the thickness of the neck at the heel go, what tolerances does Warmoth work to?
Is every single item QC'd to determine that it falls within those tolerances?
What happens to the bits that fall outside those tolerances?