evidently whomever installed my Wilkinson VS100 positioned the briddge too far forward, cause it wont float right without the springs(high tension) falling off the claw on a pull up.. It only works right when the trem is blocked up against the body for dives only.
Anyhow, I am woried about useing a standard pine dowel to fill the holes. Is there anyplace to get a harder wodd dowl like hard Maple or something.
I might have a tough time pulling the studs out since I had glued them in. I will try heating them with a solder gun, then pulling them out with the claw end of a hammer attached to the screws... but it might be hard with the vS-100, as the trem scrws are rounded of like a ball on top .
I intend on installing a six-point Fender style trem, and Ive also heard that insatlling is faqirly foolproof-just line up the trem with strings on oit- mark the holes after you edge the trem just a tiny bit back from the body? thanks
.
Anyhow, I am woried about useing a standard pine dowel to fill the holes. Is there anyplace to get a harder wodd dowl like hard Maple or something.
I might have a tough time pulling the studs out since I had glued them in. I will try heating them with a solder gun, then pulling them out with the claw end of a hammer attached to the screws... but it might be hard with the vS-100, as the trem scrws are rounded of like a ball on top .
I intend on installing a six-point Fender style trem, and Ive also heard that insatlling is faqirly foolproof-just line up the trem with strings on oit- mark the holes after you edge the trem just a tiny bit back from the body? thanks
.