Drill Bit Size

[Colin007]

I'm going to be drilling the holes for the little guide pins for my Sperzel tuners. The directions call for a 2.7mm bit but all I can find is 2.8mm without having to order it online. It's it going to make a big difference or will it be fine?

 

[AutoBat]

A bit 0.0039 inches larger will be fine.  The holes are just extra insurance to keep the tuners from spinning around when you wind up.

 

[Colin007]

That's what I figured. I know there are instances in a build where thousandths of an inch are important but I think I can get away with it here.