Confused???

[jackthehack]

How do you install/run the wires from the pickup switch to the controls? Looks like it's missing an access plate...


http://www.warmoth.com/Showcase/ShowcaseItem.aspx?Body=2&Type=92&Path=Mooncaster&i=MP547#.V99nPzMrLnB

 

[pabloman]

It's hollow and that switch isn't too far from the control cavity. The couple of hollow bodies I've worked on didn't have any cavity covers. I rewired a Ghost setup on a Schecter C1 A/E and installed some ZW EMG's in an Epiphone Studio Dot. You basically go fishin through the f hole and the pickup cavities.

 

[line6man]

You do it the same way you would do with any other hollowbody. That is to say, it's a PITA, and you do it any way you can manage. One way is to tape a piece of string to the switch, and pull it through the hole.

 

[Cagey]

That's a sharp body! Black binding around a clear vintage tint finish on swamp ash...mmmm

 

[DangerousR6]

If it's full hollow, then when the cavity cover is off you should be able to see down to the horn where the switch hole is... :icon_thumright: