AxeMasters preslotted nuts

[dmraco]

Anyone use AxeMasters pre slotted nuts?  I have them pre slotted in brass?  The site says they fit WARMOTH.  I would rather not cut a nut, and figured this may be a better method.  I can always add/remove bottom material to adjust the height.

Check them out.
http://www.ebay.com/sch/i.html?_nkw=axemasters+nut

 

[Cagey]

I've bought a couple brass ones from them - one standard and one compensated - but I haven't used them yet. I just dry-fit them to see how they'd look/fit, which seems to be fine. I'm not sure the compensated part is as accurate as it could be, just visibly comparing it to a typical Earvana part. But, it's probably better than nothing. It remains to be seen whether my nut files will deal with brass well without losing their bite.

 

[dmraco]

I really like the brass one I put into my g!bs0n Jr. Replica.  Super sustain.  These come sdotted too. I think it may be a good option over a warmth nut

 

[Cagey]

I've got a Tele in progress that I'm going to put one on, just so it matches the gold frets. But, I had a brass nut on an SG 100 years ago that I liked ok, for the reasons you mention, so I'm sure I'll be happy.