Anyone make a bezel for a 3-way switch?

[Professor Bill]

Hello!

I have a project underway with a rear-routed 3-way blade switch (Telecaster style) that has a little damage that I'd like to cover with a small plate or bezel. I'm imagining something very minimal that attaches through the same screws as the switch itself and is just wide enough to surround the screw holes – like an elongated lozenge shape – and fairly thin , +/- .06" and in black bakelite, thin metal or something like it.

I've seen a fairly chunky, ugly option on eBay, but was hoping for something simpler.

Any ideas – or can folks direct me to a person who might be able to fabricate something like this?

Thanks much!

 

[Verne Bunsen]

Forum member DangerousR6 has done a lot of custom fab work for folks around here, I would touch base with him. Keep in mind the travel of the switch lever, the thicker the mounting surface becomes the more likely you are to impede it.

 

[Logrinn]

Göldo makes one

 

[Professor Bill]

That might be the way to go. Shipped from EU, but available on Reverb.

Göldo makes one