Recent content by ieruiz

Omg!  That was exactly the problem!  1M thank you's!!!

All, I just installed Bareknuckle Mother's Milk pickups on my warmoth rear route body/guitar using guidance from this Warmoth video:  https://www.youtube.com/watch?v=-UNKIoIomKs So they're wood mounted.  But Instead of using foam, I installed springs to raise/lower the pickups to the right...

Got it.  I guess another option is to take the trem  block to a grinding wheel and taper it off a bit. 

I've got a Gotoh 510TS fe1 installed in my Warmoth body - which was routed for a 510.  But when I depress the whammy bar, the block hits the back of the cavity and stops prematurely.  Not sure what to do beyond taking a chisel to the back of the cavity and removing material.  Any advice? Isaac

I did the finish.  I used Feibling's leather dyes.  Alcohol based.    Then about 8 cans of spray on lacquer, followed by wet sanding, then final buffing. 

Pickups and controls go in next.

The dowel rod/sandpaper method worked very nicely.  I have  a new issue.  I guess that the Gotoh 510TFE1 routings are just enough different than Fender American Standard that the lateral alignment is off.  Needs to come about 1/8" laterally toward the player so that the strings are exactly...

Warmothers, Seeking advice.  Just got my Warmoth chambered strat body but made the point-and-click mistake of specifying standard Fender bushing holes which are about 9.5mm.  But I've got a Gotoh Trem with 10mm bushings.  Would like advice on widening the holes without splintering the area...