rogerzilla
Junior Member
- Messages
- 27
The neck came a few weeks ago - just plopped a few parts on for the photo. It all lines up beautifully, and the neck is almost an interference fit in the pocket. I wondered about a white scratchplate, but black sets off the fretboard better, I think.
Body: Warmoth Tele, standard routing, alder with flame maple top, greenburst
Neck: Warmoth Vintage Modern, maple with ebony fretboard, 22 stainless steel frets (small vintage size), headstock truss rod adjustment
and in a big box upstairs, some of which are on the photo:
Pickups: Seymour Duncan Vintage Stack mini-humbuckers
Tuners: Gotoh replica Klusons
Scratchplate: Allparts 11 hole black/white/black
Control plate: Allparts
Pots: CTS 500k audio taper
Knobs: mystery push-fit replica domed Tele knobs
Switch: Fender 3-way
Cap: Vitamin Q oiled paper 0.022 microfarad
Bridge: Wilkinson compensated vintage Tele bridge
Jackplate: Electrosocket
Ferrules: Fender AM Series
Strap buttons: Fender AM Series
Neck plate: Fender "F" plate
Strings: Ernie Ball .010
I now have to apply a decal to the headstock, lacquer over it and then build it all up very, very carefully. I've been collecting bits for months, and have sent back one neck and two bodies (not Warmoth - UK sourced!) because they were off-spec in some way. This stuff is perfect.


Body: Warmoth Tele, standard routing, alder with flame maple top, greenburst
Neck: Warmoth Vintage Modern, maple with ebony fretboard, 22 stainless steel frets (small vintage size), headstock truss rod adjustment
and in a big box upstairs, some of which are on the photo:
Pickups: Seymour Duncan Vintage Stack mini-humbuckers
Tuners: Gotoh replica Klusons
Scratchplate: Allparts 11 hole black/white/black
Control plate: Allparts
Pots: CTS 500k audio taper
Knobs: mystery push-fit replica domed Tele knobs
Switch: Fender 3-way
Cap: Vitamin Q oiled paper 0.022 microfarad
Bridge: Wilkinson compensated vintage Tele bridge
Jackplate: Electrosocket
Ferrules: Fender AM Series
Strap buttons: Fender AM Series
Neck plate: Fender "F" plate
Strings: Ernie Ball .010
I now have to apply a decal to the headstock, lacquer over it and then build it all up very, very carefully. I've been collecting bits for months, and have sent back one neck and two bodies (not Warmoth - UK sourced!) because they were off-spec in some way. This stuff is perfect.