Hello! I’m getting last minute research together prior to ordering my replacement neck. I went ahead and measured the 3 areas listed on the site to assure fit.
Neck pocket length is listed as 3” or 76mm. I measured 77mm. This was manufactured in Japan.
Neck pocket width is listed as 2 3/16” or 56mm. I measured 56mm.
Ok here’s the tricky one for me; the neck pocket depth is listed as 5/8” or 16mm. I also see on the “side view” that the distance between the top of the guitar body and the “rear” of the fretboard end shelf is listed as 1/8” or 3mm. When I add the 16mm depth and the 3mm clearance I get 19mm which is the same amount I’m measuring on my neck stock bottom/rear up to the rear side of the fretboard end shelf.
From my perspective this looks like a good fit. If not or if I missed something, please point it out as I’d like to know before I place this order.
Thanks in advance!!
Neck pocket length is listed as 3” or 76mm. I measured 77mm. This was manufactured in Japan.
Neck pocket width is listed as 2 3/16” or 56mm. I measured 56mm.
Ok here’s the tricky one for me; the neck pocket depth is listed as 5/8” or 16mm. I also see on the “side view” that the distance between the top of the guitar body and the “rear” of the fretboard end shelf is listed as 1/8” or 3mm. When I add the 16mm depth and the 3mm clearance I get 19mm which is the same amount I’m measuring on my neck stock bottom/rear up to the rear side of the fretboard end shelf.
From my perspective this looks like a good fit. If not or if I missed something, please point it out as I’d like to know before I place this order.
Thanks in advance!!