DarkPenguin
Senior Member
- Messages
- 370
I'm going to call this done. (It still needs to be properly setup.)
After screwing around for a while this finally ended up as a black warmoth chambered body, black warmoth maple 10-16" compound radius vintage modern neck, rosewood fretboard, fixed bridge, graphtech saddles, hipshot tuners, dominger pickups (with push pull volume control turning on the bridge pickup) and pearloid pickguard.
For a new guitar that body is beaten. I might need to tether my tools to my wrists to keep from dropping them on the next body.
The neck was going to go on another guitar but in the end I couldn't match its finish with anything else. So off with the fender neck and on with the warmoth.
After screwing around for a while this finally ended up as a black warmoth chambered body, black warmoth maple 10-16" compound radius vintage modern neck, rosewood fretboard, fixed bridge, graphtech saddles, hipshot tuners, dominger pickups (with push pull volume control turning on the bridge pickup) and pearloid pickguard.
For a new guitar that body is beaten. I might need to tether my tools to my wrists to keep from dropping them on the next body.
The neck was going to go on another guitar but in the end I couldn't match its finish with anything else. So off with the fender neck and on with the warmoth.

