I have kind of an unusual wiring situation.
I have two humbuckers, and two 3-way (on-off-on), 8-pole switches (4 on each side). See below for an example.
I'm not sure how to wire them. Ideally, what I would like is for the neck to be:
1: Series
0: Off
-1: Parallel
And for the bridge to be:
1: Series
0: Off
-1: Series (phase switch)
Is this possible? Anyone know where I can get a wiring diagram for this?
These switches are normally used in Fender Mustangs, but since those are single coils, those schematics are of limited use.
I have two humbuckers, and two 3-way (on-off-on), 8-pole switches (4 on each side). See below for an example.
I'm not sure how to wire them. Ideally, what I would like is for the neck to be:
1: Series
0: Off
-1: Parallel
And for the bridge to be:
1: Series
0: Off
-1: Series (phase switch)
Is this possible? Anyone know where I can get a wiring diagram for this?
These switches are normally used in Fender Mustangs, but since those are single coils, those schematics are of limited use.