Recent content by Joe1166

Is there any full sized bridge humbucker that sounds close to a tele bridge pickup when coil tapped?

If you are going to vary on your string gauges you may not want to get the earvana because replacing an earvana nut that is filed for heavier strings is at least 60 dollars and Warmoth does not even sell earvana nuts separately so you have to buy direct from earvana and the size direct from...

Does Warmoth rout for a G and L saddle lock guitar bridge? I was wanting this kind of saddle for its extended intonation adjustment. Are there any fixed bridges like the G and L saddle lock bridge that have some extra intonation adjustability that warmoth does rout for...

Does the Hipshot bridge allow for very good intonation? Is the low E saddle able to get far enough back for very good intonation?

I was wanting to get a guitar with a fixed bridge. I used to have a guitar that had a fender flatmount and I could never drive the low E saddle back far enough to make it intonated (that guitar had a 24 3/4 in neck though). Is the hipshot hardtail bridge better for intonation? Does anyone have a...

I have a warmoth guitar that has a 1/4 deep panel jack that cuts out sometimes when I move around with the guitar. The mechanics of the cut out is when I push the input jack in hard to the jack it definitely cuts out so I put a piece of painter's masking tape on over the jack and it functions as...

The Wilkinson vs100 tremolo can do the flutter effect that a real Floyd rose tremolo does. To do the flutter effect on a Wilkinson vs100 you will either want the tremolo floating far enough away from the body so that the tremolo does not hit the body when you flutter the tremolo or you have a...

I was wanting to know if a car polisher would eventually give a lacquer sprayed guitar a gloss mirror finish. The lacquer I used is the Deft gloss lacquer...

How exactly does a person upload a picture of their guitar?

Some older post on this site show a mockingbird shape warmoth guitar body. Can a person call warmoth and have mockingbird shape body ordered special?

I found the hole and it is in the saddle stud hole and comes out the humbucker wire holes. Sorry to bother people.

The hole for the grounding wire to bridge might be the same one that that the humbucker wires come out of(it might be in the hole?). Does anyone know which stud of a TOM/STP bridge that warmoth drills for a grounding wire? I want to avoid pulling the stud that does not have the grounding wire...

I bought a diamondback body that has the TOM/STP bridge rout and I installed the bridge studs without even thinking about the grounding wire. Is there a hole for a grounding wire to one of the bridge studs and if so which stud does Warmoth use as the grounding wire stud? I cannot see a hole in...

The reverb on my amp is very high in tone and I was wanting to make it a dark reverb tone. If I changed the tank would that change the tone of the reverb? I have a mesa boogie rectoverb 50.