Untrue in my experience. I got a lot of pushback about the options I wanted. I’d have preferred to create my own radius on the fingerboard and neck profile but that was not an option even on the phone.
I’m not quite done with the design (notice the fugly sharp edges in some places on the body) but when it is done, I’d be happy to share. Working on a neck-through versión now too.
Should’ve known I’d get these bootlicking replies on here. I’ll just 3D scan their neck and share it online then. At the bare minimum, providing actual measurements of the neck that I just shelled out $650 for is a COMPLETELY reasonable request.
PS, if it is a seperate machine to add the neck radius, why don't they allow you to have NO neck radius added to your neck? That would have been totally fine for me.
I also wanted a different neck profile (boat back, actually) but that was also not offered in the admittedly obscure neck I...
I think you might be jumping to the logical conclusion of what I require a bit.
I would even simply be ok with measurements of where of where my part meets Warmoth's part.
For me, that is a simple, extremely accurate measurement of the LENGTH of the fingerboard from nut to heel of...
I am in the beginning of an insanely tough guitar build (a semi-hollow 28.225- 25.5” multiscale 7 string telecaster) with flamed maple top on mahogany using Warmoth’s Super 7 Baritone Neck (without frets so I can cut my own in that weird multiscale pattern) and it is a HUGE headache for me to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.