Warmoth Holo Strat... 7 Months In The Making...

Killswitch95

Active member
Messages
40
It took seven months for the parts to get here because the neck had to be remake, but finally, it's put together...

gu3Rt03.jpg


t59NwEB.jpg


4A8ULH6.jpg


7aii8uW.jpg


DvHicX6.jpg


meP2KFb.jpg

It's a cloudy overcast day so the Holo Flake isn't popping like it does during sunlight, but when I get those pictures I'll add them in later...

Body:

- 1 Piece Mahogany Body
- Recessed Floyd Rose Route
- Contoured Heel Joint
- Holo Flake Finish

Neck:

- AAA Flame Neck
- Full Scallops
- SS Jumbo Frets
- 43mm R4 nut route and wide string spacing
- Abalone side dot markers

Hardware:

- Black Pearl HH 3 Knob, Blade, Floyd cut pickguard
- Black Floyd Rose Original Bridge with R4 nut
- Floyd Rose Noiseless springs
- Brass Floyd Rose Tremolo claw and springs
- Seymour Duncan Cream Invader in the Bridge
- Seymour Duncan Cream Slash in the Neck
- Seymour Duncan Yngwie Low Friction Volume Pot
- Fender Tone TBX Knobs (Top knob controls Neck tone, bottom knob controls Bridge tone)
- 3 Way Switch
- Schaller M6 Staggered Tuners
- Hennessy Strap Locks
- Abalone topped control knobs
 
Last edited:

teleme01

Senior member
Messages
360
i like the allen wrench holder, kinda ala Ed Bickert, but on the back without the scotch tape
 

Killswitch95

Active member
Messages
40
i like the allen wrench holder, kinda ala Ed Bickert, but on the back without the scotch tape
Yeah I saw one in a video on some YT channel that was promoting their store and one of their guitars had one on it, and coming from previous experience with an Ibanez with the edge system I realized fishing around for a specific key for a specific guitar is a pain... Very nifty thing to have...
 
Top