Just popped for a wenge/Pau ferro neck SRV 6115 stainless screamin deal for this guy
- Thread starter Spud
- Start date
Spud
Experienced Member
- Messages
- 1,281
I had a suspicion you were hovering about ready to snag it.
JohnnyHardtail
Senior Member
- Messages
- 584
Awesome choice. I didn’t think your smoked pine guitar could get any cooler. 
Last edited:
Strat Avenger
Hero Member
- Messages
- 2,608
NICE !
JohnnyHardtail
Senior Member
- Messages
- 584
The Wenge looks shiny. Did you put an oil finish on it?
Spud
Experienced Member
- Messages
- 1,281
Nothing on it. Going to try it bare first.
Spud
Experienced Member
- Messages
- 1,281
Ok finally got some time to really go thru and set things up etc. I had to create fall away for frets 14 and up, leveled them and polished with 800 grit. I did end up using two metal shims under the LSR roller nut too. The main thing I did once again (had to on 3 previous Warmoth necks) was sand the neck heel a few mm so my bridge saddles are not angled up so far. The stamped turtle is gone but it is playing really well finally. The neck heel was in spec to begin with FYI. I have found depending on the body/ neck I like the result. Even with Warmoth body and warmoth neck I have had to adjust. Finally first time with LSR nut, looks cool/not sure if it is really doing anything special or not, but haven't had time to wiggle much yet. So far it seems like string trees will not be needed. We'll see.
Spud
Experienced Member
- Messages
- 1,281
I feel that YOU hands down are the best judge of guitars on this board.Awesome choice. I didn’t think your smoked pine guitar could get any cooler.
Similar threads
