Leaderboard

Hipshot fixed bridge with thicker baseplate

David.Bernstein

Junior Member
Messages
25
I built a Warmoth HH telecaster recently with the Hipshot bridge. Flat body (not carved) so neck pocket is not angled. No 720 mod. I bought both versions of the Hipshot bridge: the one with the 0.125" thick baseplate, which Warmoth recommends, and the thicker 0.175" baseplate. After setting up the guitar with fairly low action (1.25 to 1.5 mm, bottom of string to 12th fret distance) I found that both bridges work. Ended up using the thicker one because with the thinner bridge the saddle height screws were extended pretty far. I'm sure this would have been fine but I just liked the thicker plate better. Below is a (not very good) picture of what the saddles look like after the full setup. Basically posting this in case someone out there is wondering what the difference is in practice.


IMG_4799.jpg
 
Thanks for posting about this. What if warmoth could offer a slightly deeper neck pocket for use with hardtail bridges, around 0.050” deeper than standard. What do you think?
 
Back
Top