Leaderboard

Depth help

Fender.Fan

Junior Member
Messages
137
So I’m doing a 7/8 strat project, and I’ve ordered the best electronics I could come up with, after installing all the pots onto the pickguard I’m worried it won’t fit into the body. I haven’t gotten the body yet so I can’t test it, doesn’t anyone know the depth of a strat? (Control route)
 
You should have a ton of space in there for concentric pots, push-pulls, etc.  Just don't go trying to mount a corn cob in there!
 
It was a tbx tone knob and a push pull. They’re smaller then the switch, so it should be fine! I was gonna add a momentary kill switch but I just couldn’t make room for it
 
Your third pot could be a Shadow Kill Pot, ie a killswitch in a pot. I put one in my Mustang:

150989738858413800_resized.jpg
 
I didn’t think I’d have room for the killswitch, but when it came in it was considerably smaller than I was expecting, so I wired it in!

@logrinn it’s a 7/8 so only two knobs!

XdaGSb1.jpg


Soc0ur2.jpg
 
Ahh a 7/8.  I have been curious if I can get 3 rather than 2 pots into a rear routed 7/8 Strat
 
Ah, I see. Well it looks like it all worked out in the end.
Looking good.  :icon_thumright:
 
Back
Top