Recent content by Stewart1983

Like what, outside of solid solder connection and correct tip + ring lug placement?

If that’s true, I’m guessing either at the grounded tab, since it’s also sharing claw ground and jack ground, or same below the switch connection lug underneath towards the lug tabs? Plus my neck pickup is not picking up any k readings. Just the bridge. Any contact locations to check with my...

Crammed? The pickup wires are pretty rigid. I’ve moved them out to avoid obstructing connection points on the pots. The only contact between braid & neck tone pot is covered with heat shrink. But even still, typically a contact like that produces a loud ground hum. This circuit as it sits is...

I’m wiring up a Strat with HxH single braid Lollar Imperials, 1 Vol w/treble bleed, 1 Neck Tone, 1 Bridge Tone, 3 way blade switch. Straight forward. Initially the Seymour Duncan wiring diagram resulted in bridge output while in the neck pickup selection, dead in middle & “bridge” position...