Recent content by RacerR

  1. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    I'll take a look at the pocket... see if anything could be interfering with the neck seating correctly.  It looks like a very clean fit, with the neck sitting securly in the pocket. The action is currently very low - lower than all my other guitars. Something does seem a little wrong to me...
  2. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    The nut was installed and cut by Warmoth.  I think that I'd try to find some way to raise the bridge with a shim before I tried to alter the neck/pocket fit. Thanks -Rob
  3. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    Hopefully the photos show what is going on...  the saddles are topped out - another 1/2 turn on the two middle string saddle screws, and the height adjustment screw comes out of the saddle. I'd really like the action to be a bit higher than it is, and with the screws out so far I don't think...
  4. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    OK - here are some shots of the bridge - the action is still low enough to produce buzzing with the bridge set this way.  The photos may not be the best (sorry bout that), it's the 1st time I've tried to post one:
  5. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    Hey - thanks for the input. Checking the action with the handy-dandy Stew Mac String Action Gauge - my action and string relief are almost exactly what you have posted (High E: just under 4/64ths at the 12th, Low E: Exactly 4/64ths at the 12th).  The relief is a little tougher to measure, (.010...
  6. R

    Warmoth Flat Mount Bridge (Narrow Spacing) Setup Question.

    Hello - I've just finished putting a guitar together using a front routed Warmoth body and neck with a narrow spaced flat mount string-thru bridge. I'm not sure what is normal for these bridges - but even with the saddle height adjusted for maximum string height, the action on the guitar is too...
  7. R

    My Warmoth Superstrat

    Hey man, sweet looking axe. I have a quick question about the bridge you have installed - did the mounting holes for the Badass fit the bridge mountin holes drilled by Warmoth? Thanks - Rob.
  8. R

    Humbucker in the Bridge and SC in the Neck position.

    Hello - I'm putting a guitar together that has a Humbucker in the bridge position and a Single Coil in the neck position.  I am planning on using a 3 way switch with a coil tap on the humbucker. My question is: Should I use a Reverse Wound/Reverse Polarity single coil in the neck position, or...
Back
Top