Recent content by LP Freak

Does Warmoth pleck their necks?

I got mine to work. If I remember correctly the two outer mounting hole were very slightly off but it still bolted up fine.

Yea it makes sense now that I think about it  :doh:

That explains it.  :yourock:

I’m not seeing an option to have a Floyd Rose nut slot cut and holes drilled when buying a neck...what gives?

There’s a guy on The Gear Page that advertises in the classified

I used a Minwax nitro rattle can from Lowe’s and it worked great.

I used a water slide decal and cleared it with a rattle can of Minwax lacquer from Lowe’s and it came out great.

I pinky swore 😳

You’re right it does fit, but damn it’s snug. I’ll probably just grab a drum sander for my Dremel and ream it out a little.

I was planning to use a standard Switchcraft 1/4” jack but it obviously requires a 7/8” hole. Is there a smaller type available that works with a 3/4” hole?

I screwed up and ordered my new build with a 3/4” hole for the input instead of a 7/8”. So what’s the best way to enlarge the hole without chipping the finish?

So how do I know if I’m actually entered?

Cool, I can’t wait to win

Ok, thanks for the clarification. It’s just kinda confusing because when ordering a neck when you’re choosing a finish one choice on the drop down menu is satin nitro. They probably ought to change that if it’s not offered any more.