Recent content by falcon514

Thanks Cagey! I'll have to take a look with my meter when I get home and check for myself. It was a cheaper pot from guitar center so maybe there was a mislabeling. I have some spare ones at home that I can swap out if it turns out to be a mislabeled linear pot. After that I may bring it by my...

Been a little while since I posted, but have run into a small snag. The wiring works out, but what I noticed is my middle pickup blend has a volume jump on the pot akin to a linear pot, but I opened it up to double check and it is an A500k. Not sure what's making it have that jump, but the blend...

Thanks for the help everyone! All wired up for my first modification and it sounds great. I've got a Seymour Duncan Mini-Hum in the neck, Eric Johnson Strat in the middle and Seymour Duncan Five Two Tele in the bridge.

Thanks so much for the help! Just wanted to double check with you on one step. For the middle pickup you said to connect ground to the lug on the righthand side. Should I have a second wire that comes out of that lug going back to ground on the back of the volume pot as shown in the diagram?

Found this diagram for a Brent Mason-style 3 knob control. Was wondering if this diagram would work with my setup as it uses stacked coils whereas I am just using standard single coils and a single conductor mini-hum in the neck. Diagram: https://imgur.com/a/HszBkWi

Thanks for the tip, I think I will go with those values! Doing some more research, I think I am going to go for the Brent Mason style blend knob for the middle pickup as well.

Just to make sure I'm following, you're recommending one 500k as a tone control for all 3 pups? 500k for volume as well?

Hey all was hoping for some advice on a build. I am modifying a Nashville Tele that I picked up. The plan is to have the following pickup configuration: Neck - Mini-Hum Middle - Strat Bridge - Tele I am still a little bit new to this and am struggling with the pot values. I know that 500k is...