Recent content by DaveG_NJ

Thanks Cagey, that's exactly what I needed to know. I can deal with a few high spots. It may be a case where some random variances aligned just right (or wrongly), like a slightly shorter (within spec) fret is behind a slightly taller (within spec). I've never seen a case with a note frets out...

Thanks. I didn't realize there was such a variance along the fret wire. As for the Fender neck, I should clarify that it was a "replacement" neck. New - never mated with a guitar. Fender advises, much like Warmoth, that fitting of the pocket may be necessary as may leveling of the frets and...

Hi there. I'm on my first Partscaster build and have been very lucky so far. I picked up a genuine Fender roasted maple Telecaster neck on Amazon (of all places). Fit was perfect. 12" radius, medium jumbo frets. Frets were perfect out of the box (and I like a low action). A truss rod adjustment...

I started looking for one of these #38 bits for a new neck that I'm waiting on. Found 'em on Stewmac, but then recalled that I swapped out two brand new Fender necks this year (with pre-drilled holes) and one had very tight alignment pin holes and the other very loose, so I thought to measure...