Leaderboard

victor's latest activity

  • victor
    victor replied to the thread Twisted neck?.
    Good morning Stratamania, thanks for your reply! I read up on some stuff on Google and took my straight edge and put it on one side of...
  • victor
    victor replied to the thread Twisted neck?.
    It's a Affinity Squire neck with a CBS headstock. Not that it helps to know that but just saying. 😳
  • victor
    victor posted the thread Twisted neck? in General Guitar Discussion.
    I bought a neck from somewhere in Az. and when I mounted it there was a gap between the neck and body as you are looking down at the...
  • victor
    victor replied to the thread CBS neck short.
    So I drilled out the holes to 1/8th inch and used 3/16th dowels that I put in my drill and held a piece of sandpaper around them and...
  • victor
    victor replied to the thread CBS neck short.
    Well, upon further evaluation, I bolted the neck on (with the gap in front), and it intonated fine but upon removing it I saw the reason...
  • victor
    victor posted the thread CBS neck short in Tech Talk.
    Hello out there! I bought a neck online for my Squire Strat. It is an old CBS Squire neck I think it said and it fits the screw pattern...
  • victor
    victor replied to the thread Oops.
    Thank You Sir!!! ☺️
  • victor
    victor replied to the thread Oops.
    I guess all that side screw does is put some pressure on the main truss rod mechanic as you tighten it to pull the neck a little...
  • victor
    victor replied to the thread Oops.
    I took some needle nostrils and removed the snapped off screw, removed the neck and tightened the big allen bolt until the neck had a...
  • victor
    victor replied to the thread Oops.
    Ok thanks, I'll check it out.
  • victor
    victor posted the thread Oops in Tech Talk.
    Hello out there, so I snapped the side truss rod adjusting screw in my Warmoth neck off. Any pointers on what to do, I guess I could use...
Show older items
Back
Top