Sorry, I breezed right past that. Exactly- the slightly thicker Warmoth pegfaces cause an issue where the aperture of smallest post from the staggered Sperzel set is partially blocked by the nut used to secure the tuner. By using a thinner washer (the stock washers are 1mm thick), I was able to...
Hi all, I think I figured out a solution to the staggered tuner height problem. I ordered some 10mm x 14mm x .3mm shim washers from ebay and used them instead of the stock washers. I found the .2s to flare out too much when tightened, and these are just barely adequate.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.