Hi Guys,
I'm building a bit of a superstrat from a Warmoth body and neck. The neck I ordered has a "reverse" Strat headstock and I bought a set of the Gotoh Staggered Height Kluson clones. I've got a set on a Mexi Strat and they work very well.
When I went to put them on the neck today I...
You could go Master Volume - Master Tone - Coil Split pot using a double ganged pot. When you turn down you it would short out one of the coils on each pickup which would give you more tonal options.
Hi Guys,
I'm doing the wiring for my rear cavity Strat project and I've got a problem. The shafts of the pots I was going to use (a Fender/CTS 250k and a Fender/CTS 250k "No Lad") are too short and there isn't enough shaft exposed (lol) for me to tighten the nut on.
Any suggestions (parts...
The tuner bushings are now on...they just needed a very small amount of filing before I was able to tap them into place with a hammer and a bit of wood. I did consider getting a rubber hammer but I couldn't justify the cost lol
Next job will be the fit the tuners and then drill the strap...
Update on the tuners: the tuner holes are only slightly too small for the Gotoh bushings...I was able to open the holes up a tiny amount with a round file and the bushings fit perfectly now. No need to ream them (thank god!).
Next thing to do are the strap buttons, then the wiring. Will take...
The only things I am worried about are drilling the holes for the strap buttons and I'm going to have to ream the holes for the tuners as the Gotoh Staggered Klusons I'm going to use have ferrules slightly too wide for the standard Kluson holes.
Hi Guys,
I've just started putting my showcase Strat together...At the moment I've drilled the humbucker mounting ring and the screw holes for the back cover. I've fitted a GFS Vintage Trem (with steel sustain block) but I've fitted it with some "brass" (according to the EBay seller - but they...
Hi guys, I'm about to start working on my Strat build but I need some advice.
Specifically...what diamater drill bit do I need to drill the strap buttons, the humbucker mounting ring and the electrosocket....I'm planning on using a Bosch minidrill that uses metric hex HSS drill bits.
Any...
I used to have a neck through Soloist...I couldn't tell if there was any difference in the sustain...all I know is I'd rather have a bolt-on as if there was a problem with the neck, at least with the bolt-on you can fit a new one.
Here's a pic I took when I got home last night...It's not very good but I'll be taking pics as I go through the construction.
The neck isn't bolted on - I just slid it in to get an idea for how it's going to look
I've now got the body and neck....photos will be up later.
The body is fantastic. I didn't realise it had the contoured heel...the quilt maple on the swamp ash is amazing and I love the 3d effect when I turn it in the light. It's also very light which is bonus for me as I'm of the opinion...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.