Thanks again everyone for your replies. I had to handle some things for my day job earlier and was away from the forum. I went ahead and measured the neck and the pocket just now - results below (not the caliper is upside down on the body)
The baritone neck is a bit wide at the bottom and you can clearly see the machining where the fingerboard sits proud of where the neck pocket begins. My guess is that Warmoth probably should have taken a few more passes on the pocket width during this machining process. this may be a Baritone...
Thank you all for responding. I do have a digital caliper and a few traditional vernier calipers (I used to work as an apprentice machinist many years back). At the end of the day the measurements were kind of irrelevant to me being that there wasn't a fit I knew I had to address either the neck...
Hi Everyone,
I just signed up and first time posting here. I'd bet this topic would be discussed quite a bit but couldn't find any posts easily discussing this question.
I just ordered a roasted maple baritone tele neck with no finish, (none needed with roasted maple) & stainless frets. The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.